Thread: Test Suspension Crystals

With this suspension some of the crystals seem to settle to the bottom even when shaken heaps.same when turned upside to draw.is there a way to mix it ie heating etc? Not sure whether id be getting the full dose.anyone used suspension?

are you talking about rwr suspension if so thats normal just shake it up use a larger needle like 21-19g and take it hurts like all shit also keep in the fridge room temp = bacteria grow when its warm.

Usually if it is settling shake while drawing it out.

Stana is the same. just give it a shake and you should be fine. I found that once i got to the end of a bottle of stana it hurt more lol.

Not rwr mate just some ug stuff.yeh thanks mate ill def go get some bigger pins these crystals look pretty big and im not sure whether they are fitting down a 23g.would putting the vial in hot water dissolve the crystals?

Originally Posted by mark01

Not rwr mate just some ug stuff.yeh thanks mate ill def go get some bigger pins these crystals look pretty big and im not sure whether they are fitting down a 23g.would putting the vial in hot water dissolve the crystals?

Heating the water would allow the bacterial a chance to grow. I wouldnt heat it...

Originally Posted by Thrasha

Heating the water would allow the bacterial a chance to grow. I wouldnt heat it...

Not good advice.Heating will not make more bacteria grow.

Mark-Is your suspension in oil or water?If you say crystals, more likely it has crashed in the oil.If it in water, the powder will go to bottom,and shouldnt crystallise.

What color is the solution?

heating will not grow bacteria but room temp or warmish temps will either keep it hot 60+ degrees or cold 4 degree's or less.

Originally Posted by anthony

Not good advice.Heating will not make more bacteria grow.

Mark-Is your suspension in oil or water?If you say crystals, more likely it has crashed in the oil.If it in water, the powder will go to bottom,and shouldnt crystallise.

What color is the solution?

my bad.

Originally Posted by anthony

Not good advice.Heating will not make more bacteria grow.

Mark-Is your suspension in oil or water?If you say crystals, more likely it has crashed in the oil.If it in water, the powder will go to bottom,and shouldnt crystallise.

What color is the solution?

its in water mate.if u let it sit the particles sink to the bottom.the solution is milky white and runs through a 25guage easily.it hurts like hell and swells up the day after injection for a few days.ive never had anything so painful.everyday shots are going to get old really quick

If im correct about where it came from the alcohol content is very high thats why it hurts so much.
particles falling to the bottom is normal, thats why it is called suspension you need to shake it to put it back into "suspension"

Is there anyway to make it less painful? I dont think i can carry on using it for much longer

not alot you can do the alcohol content is too high, you could add more sterile water to water down the alcohol levels, this "can" help a little.
You could draw in 1ml from your vial then draw 1ml sterile water into the same syringe then shake the syringe and take it.
Do not add sterile water to the vial as the test could start crashing if it is very senstive to those alcohol levels.
otherwise add it to some domoso and use as a topical cream.

Ok mark,i understand now.The solution has not crashed, the powder has just suspended to the bottom.No drama, just shake it first.

Not to sure what you can do for the pain.Maybe do as O.N said, cut it with something.Personally if i was to cut it with anything, it would be with vit b12 or distilled water.

Ok i cut it with a ml of injection water for my shot today.its a little tender already but usually the real pain sets in 12-24hrs later.time will tell i guess

Originally Posted by anthony

Ok mark,i understand now.The solution has not crashed, the powder has just suspended to the bottom.No drama, just shake it first.

Not to sure what you can do for the pain.Maybe do as O.N said, cut it with something.Personally if i was to cut it with anything, it would be with vit b12 or distilled water.

b-12 might be ok but depending on what solvents are in the b-12 it could cause a reaction or chemical change i have had this happen with something i was doing once with l-carnitine and yohimbine i had yohimbine powder and inj l-carnitine i mixed it into the l-carnitine and it changed it and made me very sick.

So just stick to the sterile water in the syringe only not the vial

Guys not sure if its the right thing to do - but to assist with the pain caused from the alchole I use to warm up the syringe when full in the microwave for like 15 seconds.

Found when doing that the pain was so much less.

Was doing this a bad thing? If not Mark this may help.

Originally Posted by Daniel

Guys not sure if its the right thing to do - but to assist with the pain caused from the alchole I use to warm up the syringe when full in the microwave for like 15 seconds.

Found when doing that the pain was so much less.

Was doing this a bad thing? If not Mark this may help.

ohh how you just destroyed some of your gear...lol
dont put it in the microwave ever microwaves are not a simple heat your food type thing they pass friggin wicrowaves through your food which heats the molecules which with steroids will start to break them down.

If you need to heat it up put it under hot water or even on something hot just not in the microwave.

Ok the shot from yesterday isnt as painful after diluting it abit but is still pretty fucking painful.very sore to touch.generally feeling like shit with tiredness,headache and i reckon im getting abit of a temperature.im going to have to stop 4 a few days till i feel beta then might try it again with a smaller dose and more dilution.anyone got any other suggestions?

Well there you go - thanks On. Good thing I joined this forum

Keep that in mind next time !

So ON - if its heated in hot water for example - would this break down the molecules? If not, would it help with the pain?